Used Part Warranty
Used engines
All parts sold by Secure Auto Parts are covered under standard warranty of 30 days unless otherwise stated in writing. This warranty applies to the engine cylinder head and block assembly and specifically excludes coverage of the following accessories: fuel injection components, carburettors, intake and exhaust manifolds, distributor, alternator, emission control devices, smog pump and components, seals, timing belt (and any related tensioner, tensioner adjusters, and/or idler bearings), timing cover, thermostat, water pump, flywheel or flex plate, pulleys, valve cover, sensors, switches, oil pan and oil pickup tube, turbocharger, and intercooler (where applicable). The above parts must be transferred from your old original engine, and must be in proper working condition. Please note that this is a used engine and not a rebuilt. There may be scratches or dents on the appearance of the engine because it is a used engine. Used engine warranty covers only its performance because this is a performance product, the warranty does not cover cosmetic or visual damage (such as scratches or dents). The warranty covers only damage to the engine which will prevent it from starting up. Rust does not constitute a warranty return. Customer is responsible for changing oil, filter and seals before installation heat tabs shall not be removed or tampered with or this could void the warranty. On all belt-driven engines, purchaser must change timing belt and set timing. Secure Auto Parts is not responsible for damage caused by a broken or stripped timing belt.
Warranty is void if:
- The engine is competitively raced.
- Any damage to engine as a result of insufficient amount of oil in the engine.
- Any damage to the engine as a result of being improperly installed.
- Loss caused by overheating of the engine, unless overheating is the direct result of failure of an internal part of the engine.
Any tune ups and adjustments in belts, hoses, filters, emission control devices, sparkplugs, ect.
The following parts must be replaced to validate Secure Auto Parts engine warranty.
Documents must be provided. These must be from a parts store on a receipt from the company and no hand written slips will be accepted.
- Spark plugs
- Thermostat and Water pump
- Timing belt or chain and tensioner
- Front and rear seals and camshaft (s) seals
- Oil and oil filter
- Water and oil sending units or pumps
- Gaskets (oil pan, intake, exhaust, valve cover and any other gasket that would be required as a regular maintenance)
- Pcv valve
Warranty may be void if in inspection Secure Auto Parts finds that above parts were not replaced at the time of installation.
Used transmissions:
Are guaranteed free of defects for a period of 30 days from the date of sale not delivery. We guarantee that it will shift properly, gears and bearings to be in good working condition. Remember there is no reimbursement for labor to install or remove.
- You must replace all seals and gaskets prior to installation weather it needs it or not ,
- If not preformed this constitutes an immediate warranty void .
- Replace oil and filter in all automatic transmissions.
- Thoroughly clean all components of the transmission including oil pan before assembly.
- Flush & flow test cooler and lines.
- Fully engage torque converter in front pump.
- Manual transmission you must install a new clutch, pressure plate, and slave cylinder. You must also have your fly wheel turned prior to installation.
- Fill and check fluid to insure proper levels.
- We strongly recommend you install an inline filter on cooling lines
- Adjust throttle pressure. Clear stored fault codes.
- Computer controlled transmissions need to have scan tool attached to check for codes.
All returns must have prior authorization from Secure Auto Parts or they will be refused. You must contact Secure Auto Parts to receive authorization prior to any returns.
If you do not follow the guidelines set forth by Secure Auto Parts in regards to seals, gaskets and installation procedures, the warranty is void.